LAKE LM26

LAKE Ref : LM26


90,00 € HT

processeur 2 IN /6 OUT + AES + DANTE 


 

Features
Module configuration 2 Contour or 4 Mesa modules
Channel processing 6 in Contour mode, 4 in Mesa mode
Input routers 8 input routers with 4 priorities in each, seamless failover to lower priorities
Module input mixer 4 ch. for Contour, 8 ch. for Mesa-modules. Mix any ratio between all input routers.
Input processing Raised Cosine Mesa and Ideal Graphic input equalizers
Output processing Linear phase or Classic crossovers, Parametric EQ, shelving and all-pass filters
Features Delay, Mute, Phase, Gain etc.
Limiters LimiterMax with Peak and RMS limiter. Configurable MaxRMSLevel, MaxRMSCorner, MaxRMSAttack
SuperModule compatible Yes
Audio Performance
Conversion resolution 24-bit
Internal Sample Rate / Data path 96 kHz / 32 bit floating point
Product propagation delay Best case (AES synchronous 96 kHz to AES synchronous 96 kHz via module) 0.871 ms Analog (Analog in to Analog out via module) 1.039 ms Pass thru (Analog in to AES synchronous 96 kHz bypassing module) 0.158 ms
Maximum available user delay 2 seconds
Analog
Inputs and Outputs 2 inputs, 6 outputs
Frequency response, digital-to-analog +/-0.03 dB, 20 Hz to 20 kHz
Frequency response, analog-to-digital +/-0.1 dB, 20 Hz to 20 kHz
THD+Noise, inputs 0.00024% typical at 1 kHz
THD+Noise, Outputs 0.00037% typical at 1 kHz
Dynamic range, inputs 116 dB
Dynamic range, Outputs 115 dB
Input impedance 20 kOhm balanced, 10 kOhm unbalanced
Common Mode Rejection (CMR) -74 dB, 20 Hz to 20 kHz
Crosstalk, inputs -98 dB, 20 Hz to 20 kHz
Dante Audio Network
Inputs and Outputs 4 inputs, 8 outputs
Supported sample rates 48, 96 kHz
Support redundant paths Yes
Flexible topology yes
Device presets
Frame presets 100
AES Inputs
Inputs and Outputs 4 inputs, 8 outputs
Supported resolutions Up to 24-bit
Supported sample rates 44.1, 48, 88.2, 96, 176.4, 192 kHz
Termination Selectable
GPIO
Inputs 2 General Purpose Inputs (GPI) supporting external contact closure
Outputs 2 General Purpose Outputs (GPO) with internal contact closure
Software configurable input control Standby state, Mute state, Dual preset recall
Software configurable output indication Standby state, Mute state, Faults, Ready
Ethernet
Gigabit Ethernet 1000 Base-T
Fast Ethernet 100 Base-Tx
Back panel Interface
Analog Inputs and Outputs 2 + 6 XLR
AES Inputs and Outputs DB-25, with selectable termination
Ethernet Ports Dual Neutrik® etherCON®
GPIO DB-9
Power Detachable locking 3-pin IEC
Control and monitoring interface Via Ethernet for Lake Controller software
Front-panel user interface
Display Daylight readable monochrome (128 x 64)
Meters LED for signal level and clip indicators per channel
LED Fault and Warning indication Yes
Parameter adjustment Single/multiple parameter edits with rotary encoder
Standby Power button On/Standby
Power
Nominal voltage 100 – 240 VAC
Operating voltage 70-265 V AC
Power consumption 30 W maximum
Dimensions
Dimensions 483 mm (19"), 44 mm (1 U), 290 mm (11.5")
Weight
Weight 5 kg (11 lbs)